Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Référence: 341/402
dimensions: 4.3 x 2.5 cm, inner diameter: 1.43 cm
Référence: 340/1
The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...
Référence: 340/2
The suckering ducts are on the model exactly on the same place as the original ones in position to the turbine on the full-size helicopter.
Référence: 341/429
Addition to the Cockpit Ord. No. 340/29 to make it look more realistic
Référence: 341/413
dimensions: 10.63 x 0.7 x 1.3 cmPack of 2, each 2-part
Référence: 330/2
The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm
Référence: 340/13
This dummy power unit can be installed on turbine powered helicopters to produce an even more realistic intersection between the turbine and the gearbox.When the imitation rotor brake of the dummy part is pushed over the turbine starter, the rubber connector is spring-loaded in front of the gearbox connection; retaining screws are not required.Dummy power...
Référence: 341/36
Load basket for Lamalength:410 mmwidth:100 mmheight70 mm
Référence: 341/407
dimensions: 6.5 x 4.5 x 6.,5 cm2-part
