Pedales llama x2 1: 4

Reference: 341/412

Turbine air entry 1:4

dimensions: 8 x 3.5 x 4.3 cm

Reference: 341/408

Oil tank small Lama 1:4

dimensions: 6.8 x 1.8 x 6.8 cm

Reference: 31/34

Joystick set

The control column and collective pitch stick are part of the basic equipment of any helicopter's cockpit.The version shown here is based on the fittings found in the full-size Schweizer 300 C...

Reference: 134/411

Antena alrededor de 1: 4

Reference: 330/10

Cabin sheath for Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Reference: 340/6

Entry step, for Lama

If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1

Reference: 134/410

Antena superior 1: 4

Reference: 341/421

Rueda de ventilador Lama 1: 4

Reference: 341/409

BTP Lama 1: 4

Reference: 330/45

Hook for Lama

The hook for the Lama is fully functional. The scale aluminium frame comes with further more accessories, inclusive servo mount.The fuselage already offers the fastening, ready soldered.On your model you mount the hook in the required location, and release dummy loads by activating a servo via your transmitter.

Reference: 341/429

Detailed Cockpit panel, Lama

Addition to the Cockpit Ord. No. 340/29 to make it look more realistic

Reference: 341/419

Cables Pulleys Lama x6 1:4

1,18 x 3,15 x 0,72 cmPack of 6

Reference: 341/507

Oil tank large Lama 1:4

dimensions: 5.15 x 3.62 x 5.1 cm

Reference: 134/444

Winch connections 1:4

dimensions:flat: 1.53 x 1.53 x 0.7 cmhigh: 1.29 x 1.29 x 1.14 cmPackage contains: 3x flat + 4x high

Reference: 1/21

Helmet for pilot William 1:4

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Reference: 341/404

Position lights Lama x2 1:4

dimensions: 4.5 x 3.2 x 1.8 cmPack of 2 (l/r)