Marchi

Nessuna marca

Fornitori

Riferimento: 92/91

Flanged ballrace 6 x 10 x 3 mm

Recensioni: 0

Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...

Prezzo 14,70 €
Più
In vendita su richiesta

Riferimento: 70/76

Aste 3,0 x 75 mm

Recensioni: 0

Ready-made pushrod, threaded M 3. Content of the package: 1 piece

Prezzo 6,30 €
Più
In vendita su richiesta
Tutte le migliori vendite

Ci sono 131 prodotti.

Visualizzati 49-60 su 131 articoli

Filtri attivi

  • Categorie: Kit motorizzazione elettrica
  • Categorie: Scarichi per Turbine
  • Categorie: Serbatoi e accessori
  • Categorie: Turbines

Riferimento: 3310

Kit motorizzazione per Meccanica Extreme

Recensioni: 0

For the conversion of Xtreme mechanics to electric, for 10 S LiPos (LiPos are not included in the set). Supplied with the drive set are: electric motor, controller, programmer, motor mount, pulley, belt, fixings Due to constantly changing supply and availability of electric motors, the motor used in this set may vary. Currently, the Pyro 700-52 from...

Prezzo 708,70 €
Più
In vendita su richiesta

Riferimento: 770/16

Exhaust tube for turbine, BK 117

Recensioni: 0

On the BK 117 the forward thrust is eliminated by the scale division of the exhaust tube (enlarging of the cross-section) and exhausting up through the rotor disc.

Prezzo 1.181,10 €
Più
In vendita su richiesta

Riferimento: 830/68

Rete a benzina fine e filtro a cherosene

Recensioni: 0

Chemical analysis used in Formel 1 is able to determine 1 g of impurity within 1 ton of oil. To fulfill your demand on the cleanness of the fuel for your model helicopter you use the fine-mesh petrol filter inside the fuel tubing between the tank and the carburettor. Also suitable for kerosine turbine fuel.

Prezzo 25,10 €
Più
In vendita su richiesta

Riferimento: 3304

Motore elettrico stabilito dalla meccanica della turbina Electro

Recensioni: 0

Incl. motor, controller, new machined motor mount Flight time, 12S LiPo, 8 Ah, approx. 12 Minutes, depending on the model weight.For use with Vario Turbine electric mechanics 1002/76, 1002/77 and 1002/78:1002/76: BK 117, Ord.No. 7700; Hughes 500E, Ord.No. 90041002/77: Bo 105, Ord. No. 6005; Airwolf, Ord.No. 2004; Bell 430, Ord.No. 4340, Bell 230, Ord.No....

Prezzo 1.396,90 €
Più
In vendita su richiesta

Riferimento: 791/16

Exhaust tube for turbine, Cobra

Recensioni: 0

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Prezzo 1.090,20 €
Più
In vendita su richiesta

Riferimento: 134/16

Exhaust tube for turbine, EC 135

Recensioni: 0

On the EC the forward thrust is eliminated by the scale division of the exhaust tube (enlarging of the cross-section) and exhausting up through the rotor disc.

Prezzo 945,50 €
Più
In vendita su richiesta

Riferimento: 830/83-50

Tubo benzina benzina 50 m

Recensioni: 0

Fuel tubing for petrolapprox. 50 mtransparentFuel tubing inevitably suffers from the effects of ageing. Always replace brittle tubing before it gives problems!

Prezzo 412,40 €
Più
In vendita su richiesta

Riferimento: 26/2

Cappuccio di gomma

Recensioni: 0

Rubber cap useful to seal fuel lines on the pit box or fuel tank nipples pack of 4

Prezzo 4,00 €
Più
In vendita su richiesta

Riferimento: 3311/1

Combustione elettrica per X-Treme 8701

Recensioni: 0

For the conversion of Xtreme mechanics to electric, for 10 S LiPos (LiPos are not included in the set).Supplied with the drive set are: electric motor, controller, programmer, motor mount, pulley, belt, fixingsDue to constantly changing supply and availability of electric motors, the motor used in this set may vary. Currently, the Pyro 700-52 from...

Prezzo 708,70 €
Più
In vendita su richiesta

Riferimento: 904/16

Exhaust tube for turbine, Hughes

Recensioni: 0

The shape and dimensions of the Hughes fuselages allow for the installation of a three outlet exhaust. The outlets on the left and right hand sides offer the necessary cross-section and greatly reduce the forward thrust. This keeps the scale rear outlet while only discharging a small amount of the total exhaust gas.

Prezzo 803,00 €
Più
In vendita su richiesta

Seguici su Facebook