Collective pitch compensator 12 mm

Riferimento: 480/53

Co-rotating dome coverage-set

You can fit to your Chinook heads a plate each that covers the dome and spins with the rotor head rpm. A pretty detail, that also can be found on the original Chinook helicopters. The plates / dome covers are mounted on the clamp rings of the main shafts.Pack of 2 plates incl. mounting material

Riferimento: 87/21

Washer for actuator arm 2.5 x 9 mm

Washer for actuator arm Content of the package: 2 pieces

Riferimento: 76/15

Portapala in VTR, rinforzato M4

Blade holder, GRP, reinforced

Riferimento: 71/26

Forcelle nylon trascinatore

Curved link Content of the package: 2 pieces

Riferimento: 82/52

Spacer washer for SKS rotor head

Spacer washer for SKS rotor head Content of the package: 2 pieces

Riferimento: 71/14

Bracci passo compensatore

Pack of 2

Riferimento: 54/16

Clamp ring pitch compensator 17 mm

The 17 mm Ø clamp ring is fitted to the rotor head centre piece, the steel pin slides in the guide slot of the pitch compensator. Rotate the clamp for fine adjustment so that your helicopter flies straight when you apply a pitch-axis command.Clamp ring for pitch compensator 17 mm Ø, length of the pin 30 mm.

Riferimento: 87/12

Doble bola-link para Delta rotor

Riferimento: 832/55

Clamp ring, mixing base

Clamp ring for pitch compensator

Riferimento: 79/13

Flybar stainless steel 4 x 560 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Riferimento: 10/81

Tubo silicone 5 x 7 x 100 mm

 Silicone sleeve5 x 7 x 100 mmtransparent

Riferimento: 91/60

Paddles

 Paddles1 pairapprox. 29 g eachfor 4 mm Ø flybar

Riferimento: 82/30

Rocker kit Bell UH / Bell 212 / Bell 47

Not available

Riferimento: 82/51

Bellcrank

Not available

Riferimento: 82/9

Aluminium rocker

When you use a speed regulator you put the magnets into the cut-outs of this clamp ring. Clamp ring for speed collection, 10 mm Ø.

Riferimento: 722/71

Collective pitch compensator 12 mm

Pitch compensator, complete, for 12 mm Ø main shaft, centre piece aluminium.For use with the rotor head Ord.No. 722/72.