Rotor head centre piece, rigid

Riferimento: 10/81

Tubo silicone 5 x 7 x 100 mm

 Silicone sleeve5 x 7 x 100 mmtransparent

Riferimento: 86

Ball collet 4 mm

Ball collets provide the fixation of double ball-links on the flybar, in order to settle the essential distance to the rocker. Ball collet 4 mm Ø, pack of 2, chrome-plated.

Riferimento: 704/39

cabezal de rotor de 4 palas 15 mm

Riferimento: 74/7

Rotor head dampers for 2 blade FBL systems

Flybarless electronics have now become common. Where they are being used harder damping is required.For these cases Vario is now offering a harder damping of the blade shaft provided by a pretension absorbing element in the centre block.For the adjustment, the outer O-ring position can be selected between "hard" and "soft" flight characteristics.Important...

Riferimento: 91/60

Paddles

 Paddles1 pairapprox. 29 g eachfor 4 mm Ø flybar

Riferimento: 76/19

GRP blade holder, 5 mm ∅ hole

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with short linkage armfor multi-blade rotor heads

Riferimento: 72/22

Rotor head centre piece, rigid

Aluminium centre piece, rigid, for 12 mm main shaft

Riferimento: 80/10

Ponte compensatore di passo

The control bridge actuates the flybar. The servos pass the control commands to the swashplate. The collective pitch compensator connected to the swashplate transfers the movement to the control bridge via the angled pushrods. The flybar accepts the control commands and passes them on to the blade holders and the rotor disc.Control bridge, GRP, for 4 mm ∅...

Riferimento: 705/33

5-blade centre piece 12 mm

Component part for a multi-blade rotor head for 12 mm Ø main shaft; see Ord.No. 703/32, 704/32 resp. 705/32.

Riferimento: 702/79

Flybar stainless steel 5 x 270 mm

Pack of 2

Riferimento: 832/75

Thrust washer

Thrust washer for rotor head Content of the package: 2 pieces

Riferimento: 78/45

Mixer lever set, aluminium

These mixer levers from aluminium are particularly torsion proof and feature an improved control precision. For individual settings you can change the connection of the linkage (relocate the balls).Flanged bearings 3 x 7 x 3 mm are suitable also, i.e. you use existing ballraces again.Place of installation: all rotor heads which are provided with the...

Riferimento: 72/1

Freno rotore ø oltre 2 m.

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments. Pease note: stay in safe distance away from the turning...

Riferimento: 702/90

Aluminium centre piece

Aluminium centre piece for 12 mm Ø main shaft

Riferimento: 703/31

3-blade centre piece, 10 mm

Item to a multi-blade rotor head for Ø 10 mm shaft; see Ord.No. 703/30, 704/30 and 705/30.

Riferimento: 82/30

Rocker kit Bell UH / Bell 212 / Bell 47

Not available