Ball-collet with double ball

Référence: 117/20

Thrust bearing set complete

The standard version of our mechanics includes ground thrust bearing shafts with a of 8 mm Ø and a length of 110 mm.Thrust bearings absorb the high centrifugal forces exerted by the main rotor blades. The effect of the axial bearings is retained in full when the blade holders rotate.Thrust bearing set, complete as shown.

Référence: 74/14

O-ring 3 x 16 mm soft

O-ring 3 x 16 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 87/21

Washer for actuator arm 2.5 x 9 mm

Washer for actuator arm Content of the package: 2 pieces

Référence: 702/15

15mm 2 blade centre piece

Aluminium centre piece for 15 mm Ø main shaft

Référence: 71/14

Bras de compensateur

Pack of 2

Référence: 71/20

Compensateur de pas Ø 10 mm

Pitch compensator, complete, for 10 mm ∅ main shaft, centre piece GRP

Référence: 87/12

Doble bola-link para Delta rotor

Référence: 76/18

Blade holder twin blade bolt

Component part for a multi-blade rotor head for 10 mm or 12 mm Ø main shaft.

Référence: 832/77

Spacer washer 6.0 x 21.8 x 4.0 mm

Spacer washer for rotor headContent of the package: 2 pieces

Référence: 702/95

Spring for rotor head Bell 47

 Content of the package2 pieces

Référence: 82/51

Bellcrank

Not available

Référence: 68/22

Aluminium side frames

Aluminium side frames for swashplate driver 68/20 and 68/50. Content of the package: 2 pieces

Référence: 78/41

Mixer lever cranked

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...

Référence: 74/19

Joint torique, souple 1.5 x 19 mm

O-ring 1.5 x 19 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 72/45

Aluminium centre piece, 12 mm

Aluminium centre piece for 12 mm Ø main shaft

Référence: 76/8

Ballrace spacer, steel

Ballrace spacer, steel Content of the package: 1 piece.