Home
Marchi

Nessuna marca

Fornitori
Migliori vendite
Flanged ballrace 6 x 10 x 3 mm Anteprima

Riferimento: 92/91

Flanged ballrace 6 x 10 x 3 mm

Recensioni: 0

Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...

Prezzo 14,70 €
Più
In vendita su richiesta
Aste 3,0 x 75 mm Anteprima

Riferimento: 70/76

Aste 3,0 x 75 mm

Recensioni: 0

Ready-made pushrod, threaded M 3. Content of the package: 1 piece

Prezzo 6,30 €
Più
In vendita su richiesta
Tutte le migliori vendite

Ci sono 420 prodotti.

Ordina per:
Rilevanza Nome, da A a Z Nome, da Z ad A Prezzo, da meno caro a più caro Prezzo, da più caro a meno caro
Visualizzati 145-156 su 420 articoli

Filtri attivi

Tuned pipe silencer Anteprima

Riferimento: 116/70

Tuned pipe silencer

Recensioni: 0

 Tuned pipe silencerangled endsoverall length 390 mmconnection-Ø 20 mmoverall Ø 40 mmsilencer chamber 230 mmweight approx. 180 gtail pipe length 98 mm

Prezzo 176,40 €
Più
In vendita su richiesta
Charger for 12 V starter... Anteprima

Riferimento: 3491

Charger for 12 V starter battery

Recensioni: 0

Use this battery charger to recharge the starter battery; mains connection for 230 V. Charger for 12 V starter battery

Prezzo 54,60 €
Più
In vendita su richiesta
Silencer for 116/95 Anteprima

Riferimento: 116/94

Silencer for 116/95

Recensioni: 0

Silencer, aloneIntake pipe 170 mmSilencer chamber 195 mmOverall Ø 50 mm

Prezzo 269,70 €
Più
In vendita su richiesta
PTFE tape 0.1 mm Anteprima

Riferimento: 115/12

PTFE tape 0.1 mm

Recensioni: 0

To seal a fuel tank unscrew the cap and wrap 3 - 4 layers of PTFE tape round the threaded section. Screw the cap back on the tank as far as it will go.PTFE tape 0.1 mm12 mm wide, 12 m long

Prezzo 11,20 €
Più
In vendita su richiesta
Teflon Tubo 20x2, 5x120mm Anteprima

Riferimento: 115/5

Teflon Tubo 20x2, 5x120mm

Recensioni: 0

Manifolds and tuned pipes or silencers must be installed without touching each other, because the contact of these metal parts could cause radio interference. We can refer to this interference as "electric noise". The connection by PTFE pipe enables the required distance of 10 - 15 mm in the prescribed position, and it steadily seals gas-tight. This...

Prezzo 19,40 €
Più
In vendita su richiesta
Sistema di rifornimento di... Anteprima

Riferimento: 13/32

Sistema di rifornimento di cherosene

Recensioni: 0

The kerosene refuelling system is sealed with a rubber nipple. The constant low pressure inside the tank draws the nipple firmly against the refuelling opening. That is also the reason why a mechanism such as a spring-controlled valve is not suitable, because the low pressure tends to push the spring back as spring tension diminishes.

Prezzo 46,10 €
Più
In vendita su richiesta
Tuned pipe silencer Anteprima

Riferimento: 116/71

Tuned pipe silencer

Recensioni: 0

 Tuned pipe silenceroverall length 400 mmconnection-Ø 20 mmoverall Ø 40 mmsilencer chamber 240 mmweight approx. 180 gtail pipe length 100 mm

Prezzo 176,40 €
Più
In vendita su richiesta
lining 45 x 40 x 12 mm Anteprima

Riferimento: 64/8

lining 45 x 40 x 12 mm

Recensioni: 0

Friction between the flywheel and the clutch bell result in a certain amount of wear of the clutch lining.For installation you slightly grind one of the outer edges. Afterwards you press the liner with that edge in front into the clutch bell. To glue in a new clutch liner you use e.g. UHU plus endfest 300, Ord.No. 10/26 or 10/27.Fits the glow plug motor...

Prezzo 27,40 €
Più
In vendita su richiesta
Swashplate driver 10 mm Anteprima

Riferimento: 68/20

Swashplate driver 10 mm

Recensioni: 0

Where a pitch compensator sits and two pushrods connect to the flybar, this is now a swashplate driver in its place.This is necessary to drive the inner ring of the swashplate in order to always control the blade angle in the same position.Aluminium swashplate driver with 4 ballraces.

Prezzo 87,20 €
Più
In vendita su richiesta
Cooling fan for petrol engine Anteprima

Riferimento: 830/67

Cooling fan for petrol engine

Recensioni: 0

This additional fan supports the cooling system of the petrol engine and at the same time the air is drawn constantly out of the fuselage.

Prezzo 30,60 €
Più
In vendita su richiesta
Torna all'inizio

Seguici su Facebook

Facebook