Attrezzi / Colle / Lubrificanti

Riferimento: 11/55

Tap M 5.0 HSS

Good thread-cutting oil is as important as the tap, as it extends the useful life of the tool several times over.

Riferimento: 10/4

Collective pitch adjustment jig

Riferimento: 11/43

Hole-cutter, 3 to 14 mm diameter, with handle

The pointed tip and the extremely sharp, double-edged blade of this tool are particularly good for cutting holes in thin materials such as GRP and other plastics. The hole-cutter requires no centre-punching and no pilot-hole, and produces a neat hole of infinitely variable diameter within the range 3 to 14 mm. The handle doubles as protection and storage...

Riferimento: 10/41

Digital collective pitch adjustment jig

Not available

Riferimento: 11/68

Twist drill 6.0 mm

We supply all required sizes of drills and taps for the work on your model helicopter.

Riferimento: 11/69

Drill set 4-part

Most hardware stores offer a very good range of tools like drills. However, when you need special sizes for our special helicopter application, it is very helpful to have a drill set handy which includes exactly the right diameters.  Typical applications: Drill 1.8 mm Ø for flange-head self-tapping screwsDrill 2.0 mm Ø for M 2.5 threadsDrill 2.5 mm...

Riferimento: 68/17

Swashplate jig

Use this swashplate jig to adjust the pushrods of the X-Treme, X-PERIENCE, XLV and Robinson R22 mechanics.

Riferimento: 68/4

Swashplate jig

The pushrods from the swashplate to the rotor head must be set to identical lengths.Just slip the swashplate jig under the swashplate, and the swashplate will automatically be set parallel to the dome plate and at right-angles to the rotor shaft. You can now set up all your linkages with confidence.

Riferimento: 11/70

Twist drill 1.5 mm

When screwing together parts in the mechanics (direct linkage) Allen screws are preferable to normal screws; use M 2.5 for Futaba servos and M 3 for Graupner / JR servos. We supply all required sizes of drills and taps for the work on your model helicopter.

Riferimento: 11/71

Twist drill 2.0 mm

When screwing together parts in the mechanics (direct linkage) Allen screws are preferable to normal screws; use M 2.5 for Futaba servos and M 3 for Graupner / JR servos. We supply all required sizes of drills and taps for the work on your model helicopter.

Riferimento: 79/1

Flybar spirit level

To adjust the pitch of the main rotor blades accurately it is essential to set the flybar exactly horizontal. This is done by simply hanging a spirit level from the flybar. But make sure that the helicopter is standing on a level surface before you start!

Riferimento: 11/72

Twist drill 2.5 mm

When screwing together parts in the mechanics (direct linkage) Allen screws are preferable to normal screws; use M 2.5 for Futaba servos and M 3 for Graupner / JR servos. We supply all required sizes of drills and taps for the work on your model helicopter.