Home
Marchi

Nessuna marca

Fornitori
Migliori vendite
Flanged ballrace 6 x 10 x 3 mm Anteprima

Riferimento: 92/91

Flanged ballrace 6 x 10 x 3 mm

Recensioni: 0

Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...

Prezzo 14,70 €
Più
In vendita su richiesta
Tutte le migliori vendite

Turbine-Mechanics for Lama (Jakadofsky Pro Edition/5000)

1002/65
Valutazione 

Designed for use with the Jakadofsky Pro Edition (25-tooth clutch bell) in a model helicopter such as the Lama.

The picture shows the mechanics in the installed state; the set is supplied in kit-form, i.e. not assembled. The Lama fuselage kit, Ord.No. 3401, is supplied with this mechanical system.

If you wish to use the mechanics in any other model, it is imperative that you install an equivalent to the rear turbine brace, shown red in the drawing.
This mechanical system must not be operated without the rear brace.

2.415,50 €
Tasse incluse
Quantità
In vendita su richiesta

 

Política de seguridad

 

Política de envío

 

Política de devolución

Descrizione

Designed for use with the Jakadofsky Pro Edition (25-tooth clutch bell) in a model helicopter such as the Lama.

The picture shows the mechanics in the installed state; the set is supplied in kit-form, i.e. not assembled. The Lama fuselage kit, Ord.No. 3401, is supplied with this mechanical system.

If you wish to use the mechanics in any other model, it is imperative that you install an equivalent to the rear turbine brace, shown red in the drawing.
This mechanical system must not be operated without the rear brace.

Dettagli del prodotto
1002/65
Documenti Allegati
Scarica
1002/65

Scarica (1.56M)
Recensioni

Ancora nessuna recensione da parte degli utenti.

Scrivi la tua recensione

Turbine-Mechanics for Lama (Jakadofsky Pro Edition/5000)

Turbine-Mechanics for Lama (Jakadofsky Pro Edition/5000)

Designed for use with the Jakadofsky Pro Edition (25-tooth clutch bell) in a model helicopter such as the Lama.

The picture shows the mechanics in the installed state; the set is supplied in kit-form, i.e. not assembled. The Lama fuselage kit, Ord.No. 3401, is supplied with this mechanical system.

If you wish to use the mechanics in any other model, it is imperative that you install an equivalent to the rear turbine brace, shown red in the drawing.
This mechanical system must not be operated without the rear brace.

Scrivi la tua recensione
13 otros productos en la misma categoría:

Seguici su Facebook

Facebook