

Ninguna marca
Referencia: 34/38
Palas del rotor de cola Juego de 2 palaslongitud = 130 mmancho = 35 mm13 gsimétricopara portacuchillas con portacuchillas de 5 mm (¡no para portacuchillas Vario!), 1 orificio, Ø 3 mmcompatible con NHP
Set Joystick
Política de seguridad
Política de envío
Política de devolución
La columna de control y el stick de cabeceo colectivo son parte del equipo básico de la cabina de cualquier helicóptero.
La versión que se muestra aquí se basa en los accesorios encontrados en el helicóptero Schweizer 300 C de tamaño completo. De hecho, las diferencias de diseño entre los componentes individuales de un helicóptero y otro son tan mínimas que realmente son prácticamente irrelevantes cuando se equipa la cabina de un modelo a escala real.
Por esta razón, el conjunto también es adecuado para la instalación en la cabina de un Hughes 500 D, Hughes 500 E o Lama, todos los cuales usan el mismo tamaño. Para evitar que el material plástico transparente se empañe al trabajar con pegamento rápido CA (Cyano), use el aerosol acelerador. Endurecerá la junta de pegamento al instante.
No hay reseñas de clientes en este momento.
Reference: 330/45
The hook for the Lama is fully functional. The scale aluminium frame comes with further more accessories, inclusive servo mount.The fuselage already offers the fastening, ready soldered.On your model you mount the hook in the required location, and release dummy loads by activating a servo via your transmitter.
Reference: 340/13
This dummy power unit can be installed on turbine powered helicopters to produce an even more realistic intersection between the turbine and the gearbox.When the imitation rotor brake of the dummy part is pushed over the turbine starter, the rubber connector is spring-loaded in front of the gearbox connection; retaining screws are not required.Dummy power...
Reference: 340/5
When full-size helicopters have to land in deep snow, the skids are fitted with "snowboards" to prevent them sinking in.On the model they look really good, and also help the pilot detect the model's orientation in the air.Make your model an eye-catcher and use some rivets for the decoration of the skies."Snowboards" for Lama, 1 pair
Reference: 350/45
Great fascination is achieved by active working details on scale models, remember e.g. rotary lights and navigation lights.A working winch adds a special attraction on a model helicopter particularly if it is pivoting and fully functional!Especially on a Alouette III you hardly need fantasy, to see instead of the model the full-size helicopter in your...
Reference: 341/402
dimensions: 4.3 x 2.5 cm, inner diameter: 1.43 cm
Reference: 340/1
The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...
Reference: 340/6
If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1
Set Joystick