Marchi

Nessuna marca

Fornitori

Riferimento: 92/91

Flanged ballrace 6 x 10 x 3 mm

Recensioni: 0

Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...

Prezzo 14,70 €
Più
In vendita su richiesta

Riferimento: 70/76

Aste 3,0 x 75 mm

Recensioni: 0

Ready-made pushrod, threaded M 3. Content of the package: 1 piece

Prezzo 6,30 €
Più
In vendita su richiesta
Tutte le migliori vendite

Ci sono 97 prodotti.

Visualizzati 1-12 su 97 articoli

Filtri attivi

  • Categorie: Alu-Tuning for 6 mm tail rotor
  • Categorie: Giunti
  • Categorie: Ricambi e Accessori
  • Categorie: Rotori di coda

Riferimento: 101/60

Aluminium 2-bladed control bridge, hole Ø8, for shaft 6mm

Recensioni: 0

Aluminium 2-bladed control bridge, hole Ø8, for shaft 6mmThis control bridge can replace the plastic conrol bridge Ord.No. 101/6. As it is made from Aluminium, it is more rigid and more resistant to heat than the standard version.

Prezzo 44,30 €
Più
In vendita su richiesta

Riferimento: 1003/10

2-blade tail rotor with GRP housing

Recensioni: 0

For the 90° tail rotor gearbox and the tail rotor itself you need to select the gearbox connection which fits the mating part fitted to the existing tail rotor drive system.Tail rotor with GRP housing, kit-form.

Prezzo 193,20 €
Più
In vendita su richiesta

Riferimento: 101/220

Aluminium 3-bladed control bridge, hole Ø8, for shaft 6mm

Recensioni: 0

Aluminium 3-bladed control bridge, hole Ø8, for shaft 6mmThis control bridge can replace the plastic control bridge Ord.No. 101/22. As it is made from aluminium, it is more rigid and resistant to heat than the standard version.

Prezzo 50,50 €
Più
In vendita su richiesta

Riferimento: 49/9

Four-screw fixing, shaft 5 mm

Recensioni: 0

Contrary to common opinion steel wires should only be degreased before mounting, but not sanded. This would cause running out-of-centre. After the change steel drive wire you should not use the grubscrews anymore. The max. force originates each with starting (turning up the system), i.e. over a longer period the shaft leaves it's marks on the surfaces of...

Prezzo 27,40 €
Più
In vendita su richiesta

Riferimento: 101/480

Aluminium 4-bladed control bridge, hole Ø8, for shaft 6mm

Recensioni: 0

 Aluminium 4-bladed control bridge, hole Ø8, for shaft 6mmThis control bridge can replace the plastic conrol bridge Ord.No.101/48. As it is made from Aluminium, it is more rigid and resistant to heat than the standard version. 

Prezzo 50,50 €
Più
In vendita su richiesta

Seguici su Facebook