Référence: 139/747

Hinges cover x2

dimensions: 1.25 x 0.98 x 0.43 cmPack of 2

Référence: 30/32

Tubos de escape Bell 222 y AIRWOLF

Référence: 340/6

Marchepied, pour Lama

If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1

Référence: 340/5

Protection contre l'enlisement pour Lama

When full-size helicopters have to land in deep snow, the skids are fitted with "snowboards" to prevent them sinking in.On the model they look really good, and also help the pilot detect the model's orientation in the air.Make your model an eye-catcher and use some rivets for the decoration of the skies."Snowboards" for Lama, 1 pair

Référence: 340/1

Support de roue pour Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Référence: 341/626

Lanzamiento colectivo 1: 6

Référence: 203/29

detailed cockpit Bell 430 + Airwolf 1:7 RTF

Not available

Référence: 901/5

Juego de herrajes Ecureuil

Référence: 341/406

Boitier électrique Lama 1:4

dimensions: 12.6 x 7 x 4.3 cm2-part

Référence: 900/417

Steps squirrel x2 1:4

dimensions: 3.4 x 3.6 x 2 cmPack of 2

Référence: 139/739

Inlet x2

dimensions: 3.16 x 1.2 x 0.9 cmPack of 2

Référence: 429/507

Antenna x2

dimensions: 10 x 2.25 x 1 cmPack of 2