CFRP gyro/receiver plate

Riferimento: 742/38

Doppelseitiges Klebeband 19 mm

Riferimento: 1409

cable clamp

The cable holder can be fixed over the eyelet. then wrap the sheathed metal strap around the cable.Length: 32 mmPack of 10

Riferimento: 10/85

Hook-and-loop tape 30 x 500 mm

Self-adhesive hook-and-loop tape gives good support to batteries, receivers etc. Components which are fastened with it can be put in and out as often as you like. The joins are not damaged in this process. Pilots in the cockpit can be fitted to their seats with a "cushion" made of this tape. blacknormal stick

Riferimento: 3503

RC connector retainer

Extension cable plugs should not loosen themselves or even come apart. The safety clip for RC-plug connections guarantees permanent contact. Pack of 2

Riferimento: 742/42

Cable tie 360 mm black

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black

Riferimento: 1406

Cable spiral tubing

Cables which could chafe somewhere on the model are best run in this flexible spiral tubing – it keeps the cables well protected. It doesn't matter whether there are two or six servo cables, the cable spiral tubing expands round the cables keeping the installation neat. Each pack has 1 m length. transparent

Riferimento: 28/17

Banana plugs

Banana plugs red and black Pack of 2

Riferimento: 1407

Cable spiral tubing

Cables which could chafe somewhere on the model are best run in this flexible spiral tubing – it keeps the cables well protected. It doesn't matter whether there are two or six servo cables, the cable spiral tubing expands round the cables keeping the installation neat. Each pack has 1 m length. black

Riferimento: 3504

Cable and tube fittings

These clips can be used for cables and tubing, and help to deploy all such items neatly inside your models. The set contents are designed to meet the needs of the typical turbine-powered helicopter. Tidily arranged leads make a considerable contribution to operational safety in your valuable model! Set complete as illustrated.

Riferimento: 25/9

Heat reflective mat

Between fuselage and exhaust tube a heat-reflecting mat avoids melting of the fibreglass. Even in smaller fuselages where conventional silencer systems are close to the inside surface, the heat reflective mat is useful as a heat shield.Heat reflective matheat rejectingsize approx. 300 x 700 mmmat thickness approx. 3 mm

Riferimento: 15/3

High-current connector set

useful for battery packs for electric helicopters

Riferimento: 755/25

Foam tube

Thickness:9 mmInside Ø:22 mmLength:250 mm

Riferimento: 15/4

High current connectors 6 mm

High current bullet connectors 6 mmincluding heat shrink sleeves

Riferimento: 3045

Push-button with rubber cap

Complete as illustrated.

Riferimento: 742/36

Cable clips self-adhesive

Cable clips made of soft aluminium in strips of four. The double-sided sticky tape adheres very well to smooth surfaces, for example on the vertical plates of the side frames. Servo cables can be routed neatly in the clips.Pack of 4

Riferimento: 742/40

Cable tie 200 mm black

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black