Stabilizzare 3-D, fibra di carbonio

Reference: 809/6

RC-Vorbau Sky Fox

Reference: 800/5

Stabiliser set red

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Reference: 800/37

Canopy holder 26 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 870/30

Streben-Set, CFK

Reference: 802/17

Strut holder - 25 mm

  Content of the package 1 piece

Reference: 260/17

Centre bearing set

 Centre bearing setincluding 2 O-ringsexcluding ballrace

Reference: 809/24

Kühlluftschacht Skyfox, rauchglas

Reference: 831/6

Adapter für Vorbau Benzin-Trainer

Reference: 260/11

Stabiliser set, XLV

GRP Stabiliser set for XLV Trainer.

Reference: 802/50

Verbreiterungs-Set

Reference: 800/4

Stabiliser set white

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Reference: 860/11

Heckrohrhalter, 2fach kugelgelagert

Reference: 860/31

Strebenanschluß-Hülse

Reference: 800/25

Stabiliser set large

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.275 mm high118 g total weightscrew fitting to tail rotor holder

Reference: 7/6

Tube drive nut M 3

 Content of the package4 pieces

Reference: 21/7

Conjunto estabilizador negro