Adhesive velcro pads 20 x 20 mm

Riferimento: 809/2

Gyro/receiver plate

A good method of mounting your gyro or your receiver is to use this aluminium plate.

Riferimento: 742/38

Doppelseitiges Klebeband 19 mm

Riferimento: 1409

cable clamp

The cable holder can be fixed over the eyelet. then wrap the sheathed metal strap around the cable.Length: 32 mmPack of 10

Riferimento: 1407

Cable spiral tubing

Cables which could chafe somewhere on the model are best run in this flexible spiral tubing – it keeps the cables well protected. It doesn't matter whether there are two or six servo cables, the cable spiral tubing expands round the cables keeping the installation neat. Each pack has 1 m length. black

Riferimento: 3504

Cable and tube fittings

These clips can be used for cables and tubing, and help to deploy all such items neatly inside your models. The set contents are designed to meet the needs of the typical turbine-powered helicopter. Tidily arranged leads make a considerable contribution to operational safety in your valuable model! Set complete as illustrated.

Riferimento: 9/21

Damping material

  Damping material approx. 60 x 250 mm self-adhesive pad for electronics and installation of tanks

Riferimento: 742/35

Cable tie 100 mm black

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black

Riferimento: 15/3

High-current connector set

useful for battery packs for electric helicopters

Riferimento: 809/3

CFRP gyro/receiver plate

The ideal method of mounting your gyro or your receiver is to use this carbon fibre plate with its reinforced cross-piece.

Riferimento: 1406

Cable spiral tubing

Cables which could chafe somewhere on the model are best run in this flexible spiral tubing – it keeps the cables well protected. It doesn't matter whether there are two or six servo cables, the cable spiral tubing expands round the cables keeping the installation neat. Each pack has 1 m length. transparent

Riferimento: 10/85

Hook-and-loop tape 30 x 500 mm

Self-adhesive hook-and-loop tape gives good support to batteries, receivers etc. Components which are fastened with it can be put in and out as often as you like. The joins are not damaged in this process. Pilots in the cockpit can be fitted to their seats with a "cushion" made of this tape. blacknormal stick

Riferimento: 3045

Push-button with rubber cap

Complete as illustrated.

Riferimento: 3503

RC connector retainer

Extension cable plugs should not loosen themselves or even come apart. The safety clip for RC-plug connections guarantees permanent contact. Pack of 2

Riferimento: 742/36

Cable clips self-adhesive

Cable clips made of soft aluminium in strips of four. The double-sided sticky tape adheres very well to smooth surfaces, for example on the vertical plates of the side frames. Servo cables can be routed neatly in the clips.Pack of 4

Riferimento: 755/26

Foam rubber sleeve

Batteries, receiver etc. are very safe in the front structure if they are packed in a foam sleeve.Many hard landings will cause no damage. The same applies to your electronic units provided that they are cossetted in a shock-absorbing foam sleeve.You just cut off the length you require.Inner diameter: 35 mmFoam rubber sleeve, approx. 250 mm

Riferimento: 742/41

Cable tie 200 mm white

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black