Pitot 41:4

Reference: 341/429

Detailed Cockpit panel, Lama

Addition to the Cockpit Ord. No. 340/29 to make it look more realistic

Reference: 134/444

Winch connections 1:4

dimensions:flat: 1.53 x 1.53 x 0.7 cmhigh: 1.29 x 1.29 x 1.14 cmPackage contains: 3x flat + 4x high

Reference: 330/31

Bubble window for Lama

Bubble window for Lama Ord.No. 3300 / 3400 / 3401, Rotor ø 2500 mm

Reference: 341/415

Llamada de rescate por radar x2 1: 4

Reference: 350/17

Exhaust cover, Ø 90 mm

When the turbine of a full-size helicopter is not running, the engine is protected with an exhaust cover which prevents foreign objects finding their way inside the turbine. This exhaust cover for model turbines is suitable for the Lama, Alouette III and any other machine with a 90 mm Ø exhaust pipe. Caution: it is essential to allow the exhaust pipes to...

Reference: 330/2

Dummy turbine, GRP

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Reference: 134/411

Antena alrededor de 1: 4

Reference: 341/408

Oil tank small Lama 1:4

dimensions: 6.8 x 1.8 x 6.8 cm

Reference: 134/455

Torch dummy 1:4

dimensions: diameter: 1.1 cm, length: 5.7 cm

Reference: 1/21

Helmet for pilot William 1:4

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Reference: 340/40

Mirror set for large-scale models

Mirror set, complete as illustratede.g. for Lama and other large-scale modelsdimensions of the mirrors: approx. 40 x 84 and 14 x 22 mm

Reference: 340/2

Scale accessories for Lama Turbine

The suckering ducts are on the model exactly on the same place as the original ones in position to the turbine on the full-size helicopter.

Reference: 340/1

Wheel holder for Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Reference: 31/34

Joystick set

The control column and collective pitch stick are part of the basic equipment of any helicopter's cockpit.The version shown here is based on the fittings found in the full-size Schweizer 300 C...

Reference: 330/36

Door latch for Lama

If you don't want that the doors of the Lama canopy close itself after opening, you use these magnet latches.

Reference: 340/29

Cockpit for Lama, turbine version