Washer 3.5 x 12 x 3 mm, rubber

Riferimento: 74/12

O-ring 3 x 12 mm hard

O-ring 3 x 12 mm hard Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 832/55

Clamp ring, mixing base

Clamp ring for pitch compensator

Riferimento: 703/41

La palanca acodada, Alu

Riferimento: 71/18

Spacer for pitch compensator 2.8 x 5 x 2 mm

 Content of the package2 pieces

Riferimento: 770/36

Spacer for rotor cap BK117

Not available

Riferimento: 74/15

Anello 2,5 x 12 mm. per Elastomero

Pack of 4Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 82/23

Washer for Delta rocker 5 mm

Washer for Delta rocker 5 mm Content of the package: 2 pieces

Riferimento: 832/69

Connecting elbow, aluminium

Connecting elbow, aluminiumPack of 2

Riferimento: 702/90

Aluminium centre piece

Aluminium centre piece for 12 mm Ø main shaft

Riferimento: 71/56

Corpo centrale per 12 mm, alluminio

Pitch mixer centre piece, aluminium, 12 mm Ø

Riferimento: 78/41

Mixer lever cranked

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...

Riferimento: 76/15

Portapala in VTR, rinforzato M4

Blade holder, GRP, reinforced

Riferimento: 79

Flybar stainless steel 4 x 450 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Riferimento: 76/25

Blade holder, blade grip 18 mm

Not available

Riferimento: 80/30

Trascinatore

Control bridge 2-part metal, for 5 mm ∅ flybar.

Riferimento: 117/20

Thrust bearing set complete

The standard version of our mechanics includes ground thrust bearing shafts with a of 8 mm Ø and a length of 110 mm.Thrust bearings absorb the high centrifugal forces exerted by the main rotor blades. The effect of the axial bearings is retained in full when the blade holders rotate.Thrust bearing set, complete as shown.