Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
You can fit to your Chinook heads a plate each that covers the dome and spins with the rotor head rpm. A pretty detail, that also can be found on the original Chinook helicopters. The plates / dome covers are mounted on the clamp rings of the main shafts. Pack of 2 plates incl. mounting material.
Política de seguridad
Política de envío
Política de devolución
You can fit to your Chinook heads a plate each that covers the dome and spins with the rotor head rpm. A pretty detail, that also can be found on the original Chinook helicopters. The plates / dome covers are mounted on the clamp rings of the main shafts. Pack of 2 plates incl. mounting material.
No hay reseñas de clientes en este momento.
Référence: 10/81
Silicone sleeve5 x 7 x 100 mmtransparent
Référence: 72/42
This rotor head hub with its bonded-in carbon fibre plates is a real head-turner. The plates are simply glued into the existing recesses on both sides. We recommend silicone rubber, Ord.No. 10/11, as adhesive.CFRP plates for aluminium hub matching Ord.No. 832/72pack quantity: 2 plates
Référence: 76/20
On all 2-blade rotor heads up to 1800 mm rotor disc different blade holders can be mounted.Blade holder set, for one blade holder
Référence: 702/90
Aluminium centre piece for 12 mm Ø main shaft
Référence: 82/9
When you use a speed regulator you put the magnets into the cut-outs of this clamp ring. Clamp ring for speed collection, 10 mm Ø.
Référence: 68/26
Swashplate link piece, straight. Content of the package: 2 pieces
Référence: 71/4
Pitch mixer centre piece, aluminium, 10 mm ∅
Référence: 54/16
The 17 mm Ø clamp ring is fitted to the rotor head centre piece, the steel pin slides in the guide slot of the pitch compensator. Rotate the clamp for fine adjustment so that your helicopter flies straight when you apply a pitch-axis command.Clamp ring for pitch compensator 17 mm Ø, length of the pin 30 mm.
Référence: 76/16
As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with long linkage armfor two-blade rotor heads
Référence: 71 A
Centre piece for pitchcompensator, GFK, alone.
Référence: 80/20
Control bridge 2-part metal, for 4 mm Ø flybar.
Référence: 832/74
O-ring 9 x 4.5 mm Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.
Référence: 82/53
Washer 3.5 x 12 x 3 mm, rubber Content of the package: 2 pieces
You can fit to your Chinook heads a plate each that covers the dome and spins with the rotor head rpm. A pretty detail, that also can be found on the original Chinook helicopters. The plates / dome covers are mounted on the clamp rings of the main shafts. Pack of 2 plates incl. mounting material.
