Servo extension lead 250 mm

Référence: 10/75

Glue dispenser

When you insert cartridges Ord.No. 10/73 into the dispenser and press the components through the mixing nozzle the epoxy is ready for immediate use.

Référence: 3942

Servo packer

Servo packing pieces are used with direct-linked JR / Graupner roll-axis servos to give clearance to the pitch-axis servo. Pack of 10

Référence: 330/18

Gear support for tail drive

Component part for fuselages like Air-Crane, Bell 47 or Lama.Pack of 3

Référence: 18/11

Aluminium tube 5.5 x 4.4 x 1000 mm

Aluminium tube 5.5 x 4.4 x 1000 mm

Référence: 3944

Servo mount 120°

When using a 4-point-linkage, the linkages from the servos run in a straight line to the swashplate.A 3-point-linkage does not permit this, here the linkages run diagonally.The 120° servo mounting enables inclined installation of the servos, and the results are straight running linkages to the swashplate.All Sky Fox based mechanics as well as on the...

Référence: 10/46

Capuchon terminal Ø 20 mm

Pack of 2

Référence: 330/10

Housse de protection pour Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Référence: 97/4

Servo linkage set

When you build your first model helicopter you will find all the linkage components required to connect the servos to the mechanics supplied with the RC set (German radio systems only). When you come to installing servos in other models you can use this servo linkage set which contains all the link balls, screws, nuts and screw-fitting pushrod...

Référence: 8/3

Tail rotor flange

The GRP tail rotor flange is used in full-fuselage helicopters such as the Jet Ranger, Bell 222 etc. to attach the tail rotor to the tail boom. The flange is supplied oversized, so that it can be fitted in all fuselages. Simply trim it to match the inside shape of the tail end of the fuselage, then glue it in place using Poxan-622 or UHU-Plus, and fitted...

Référence: 17/4

GRP bracket

 Content of the package1 piece

Référence: 3941

Servo plug lead

Servo plug leadplug for JR

Référence: 33/5

Rotorblatttasche 5-Blatt max Ø 2500 mm

Référence: 33/28

Rotor blade tie-down

Rotor blade tie-downs are an essential feature of full-size helicopter life. The tie-down protects the blades from swinging, rocking and stretching, and thereby prevents excessive pressure on the rotor shaft. If these measures were not taken the result could easily be in-flight mechanical failure; rotor blades spinning as the wind rises could strike...

Référence: 33/2

Rotor blade pouch 2-blade Ø 2100 mm

bag length: 98 cmmax. blade width: 9.5 cm

Référence: 603/19

Adaptor, tail boom rear, GRP

Component part for fuselages, Ord.No. 6030 or 6031.

Référence: 10/74

Mixer nozzles for 10/75 dispenser

 Content of the package5 pieces