Stainless steel exhaust

Référence: 144/16

Exhaust for EC 145 Turbine

stainless steelfor turbine 

Référence: 120/16

EC 120 turbine exhaust pipe

Not available

Référence: 641/16

Exhaust system for Air-Crane

right / leftThis exhaust system is designed for the Air-Crane with turbine power system.

Référence: 214/16

Exhaust for Bell 212 Twin Jet

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Référence: 344/16

Exhaust for "Starwood" Lama

Not available

Référence: 25/9

Heat reflective mat

Between fuselage and exhaust tube a heat-reflecting mat avoids melting of the fibreglass. Even in smaller fuselages where conventional silencer systems are close to the inside surface, the heat reflective mat is useful as a heat shield.Heat reflective matheat rejectingsize approx. 300 x 700 mmmat thickness approx. 3 mm

Référence: 930/16

Exhaust gas efflux for Mil Mi-2

right / leftThis exhaust system is designed for the Mil Mi-2 with turbine power system.

Référence: 904/16

Exhaust tube for turbine, Hughes

The shape and dimensions of the Hughes fuselages allow for the installation of a three outlet exhaust. The outlets on the left and right hand sides offer the necessary cross-section and greatly reduce the forward thrust. This keeps the scale rear outlet while only discharging a small amount of the total exhaust gas.

Référence: 268/16

Exhaust for XL-C

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Référence: 530/16

Exhaust efflux for CH-53

right / left

Référence: 340/16

Exhaust for Lama

This exhaust system is designed for the Lama with turbine power system.

Référence: 302/16

Exhaust, stainless steel

Exhaust system for Alouette II

Référence: 350/17

Couvercle Ø 90 mm

When the turbine of a full-size helicopter is not running, the engine is protected with an exhaust cover which prevents foreign objects finding their way inside the turbine. This exhaust cover for model turbines is suitable for the Lama, Alouette III and any other machine with a 90 mm Ø exhaust pipe. Caution: it is essential to allow the exhaust pipes to...

Référence: 530/17

Tapa de escape Ø 55 mm

Référence: 134/16

Exhaust tube for turbine, EC 135

On the EC the forward thrust is eliminated by the scale division of the exhaust tube (enlarging of the cross-section) and exhausting up through the rotor disc.

Référence: 350/16

Exhaust system for Alouette III

Not available