AIRWOLF 1:8 - Fuselage kit

Riferimento: 110/2

Foglio decalcomania UH-1D HEER

Not available

Riferimento: 110/3

Foglio decalcomania UH-1D SAR

Riferimento: 110/0

Foglio decalcomania UH-1D VIP

Not available

Riferimento: 110/1

Foglio decalcomania UH-1D WUCHER

Riferimento: 118/71

Skidbar 10 mm

 Content of the package2 pieces

Riferimento: 118/72

Skid tube 12 mm

Skid tubes for model helicopters powered by combustion engines are made of aluminium with a wall thickness of 1 mm.Specification 12 mm ØOverall length approx. 450 mmContent of the package 2 pieces

Riferimento: 110/30

Set di vetri UH-1D

 UH-1D glazing setclearnot trimmed

Riferimento: 110/33

Finestre superiori UH-1D

 UH-1D upper windowsgreennot trimmed

Riferimento: 3314/6

Conversione elettrica per SkyFox 1500 mm 6S

kit content:electric motor Kontronik Pyro 700-52 Lcontroller Kontronik JIVE 100+ LVmotor mounttoothed belt pulley 58 t. / 33 t.mounting materialKontronik TelMe can only be used with controllers Kontronik 120 JIVE Pro and higher.

Riferimento: 35/24

Albero del rotore 10 x 234 mm

 Rotor shaftfor 2-bladed head

Riferimento: 702/70

Scala semi-rotore

This semi-scale rotor head includes additional mixing of the blade holder actuator linkage at a ratio of 2 : 1. This results in well-balanced flying characteristics, and the model has a damped rather than direct response to your control inputs (resembling a 2-blade head with flybar).Use only the suggested rotor blades for flybar-less rotor heads,...

Riferimento: 110/51

Door-set right Bell UH-1D 1100

Component part for fuselage UH-1D, Ord.No. 1100.

Riferimento: 110/50

Door-set left Bell UH-1D 1100

Component part for fuselage UH-1D, Ord.No. 1100.

Riferimento: 110/9

GRP top cover Bell UH-1D 1100

Component part for fuselage UH-1D, Ord.No. 1100.

Riferimento: 110/11

Stabiliser set UH-1D

 Stabiliser set, GRP2-partfor UH-1D with a length up to approx. 1 630 mm

Riferimento: 110/32

Tail cap UH-1D

 Tail cap UH-1DGRP

Riferimento: 118/70

Skid landing gear for Bell UH-1D

with rotor disc 1670 mm

Riferimento: 110/13

Bulkhead set Bell UH-1D 1100

Component part for fuselage UH-1D, Ord.No. 1100.

Riferimento: 110/6

Tail skid UH-1D and Lynx

Component part for fuselage UH-1D and Lynx, Ord.No. 1100 and Ord.No. 7050.

Riferimento: 1002/15

Electric "Skyfox" mechanics

Including metal internal tooth gear!These are the electric Skyfox mechanics which are used with one of the following conversion sets for the required gear ratio.Mechanics excludes motor, motor mount, and motor gears... see below.Following the trend for electric models, Vario have produced an electric conversion set for the popular Skyfox mechanics. The...

Riferimento: 418

2-blade-set 1630 mm

Specification 2-blade-set length: 725 mm rotor disc: 1630 mm blade root: 14 mm 1-hole blade chord: 62 mm profile thickness: 8 mm weight: ca. 220 g material: CFRP Shark Skin finish: anthracite matt symmetry: reflex l.h.r.

Riferimento: 68/20

Swashplate driver 10 mm

Where a pitch compensator sits and two pushrods connect to the flybar, this is now a swashplate driver in its place.This is necessary to drive the inner ring of the swashplate in order to always control the blade angle in the same position.Aluminium swashplate driver with 4 ballraces.

Riferimento: 34/7

Tail rotor blades 102 mm, grey

Tail rotor blade, rotor disc 276 mm ØSpecification 8.0 mm blade root9.8 g approx.20-28 mm blade chordinj. moulded GRP3.5 mm profile thicknessdouble reflex102 mm longbalanced1 pair

Riferimento: 49/9

Four-screw fixing, shaft 5 mm

Contrary to common opinion steel wires should only be degreased before mounting, but not sanded. This would cause running out-of-centre. After the change steel drive wire you should not use the grubscrews anymore. The max. force originates each with starting (turning up the system), i.e. over a longer period the shaft leaves it's marks on the surfaces of...

Riferimento: 995

RC system accessories incl. 5 servos

If you already own a radio control system and then purchase a second model helicopter, the next step is to consider carefully which electronic components are the best choice for the new model.The combination illustrated here comprises accessories which have proved excellent in practice. RC system accessories, with Futaba BLS 452 servos excluding radio...

Riferimento: 5/205

Coffee mug BELL UH

Not available