The canopy retainer set helps to keep your canopies undamaged for a long period. It absorbs movement, such as abrupt shocks in hard landings, and prevents cracks developing in the canopy.Knurled nuts are used to hold the canopy in place, and they do not intent the canopy when tightened.The components of the canopy retainer system are screwed against...
These ball-end bolts offer an optimal connection between a GRP servo output arm and the pushrod to the mechanics. Underneath the output arm you lock the ball-end bolt with an M 2 hexagon nut. For aluminium output arms you use ball-end bolts Ord.No. 060/7 and thread-lock fluid.
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a...
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a sticker. Do not remove the foil with your finger nail, this could stretch the edge of the foil. The tip of the scalpel would best suit your purpose, and you put it on one edge of the sticker, to slide it between the foil and the paper. If it does not work take hold just before the end of the edge with thumb and forefinger. Than quickly move the scalpel with the other hand up and down over the edge. Now it should be no more a problem to pull out the foil easily from the paper. Do not touch the foil on the adhesive side (fingerprints!), but hold it still with the scalpel, until it is fixed in the correct position on the model.
Decal sheet MEDICOPTER 117factory-trimmedPre-cut transfer sheets make it much easier to apply a colour finish to your model: Clean the fuselage carefully, separate the individual items from the transfer sheet, leaving them oversize, and cut only the backing film through the centre line of the sticker (do not cut through the sticker!). Position it on the...
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a...
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a...
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a...
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a...
Painting of a registration is more difficult than painting the complete fuselage. The registration is available in black and white lettering, font size 50 mm, 44 mm and 30 mm, as a complete set....
Ready-made, pre-cut decal sheets simplify the finishing stage of helicopter construction very greatly, not to mention the enormous time saving. It is best to use the "soapy water" method for applying large transfers, particularly when they are to be stuck onto curved surfaces. The wet transfer can then be slid around on the surface, allowing accurate...
TransferGerman flag black-red-golddimensions: 1,5 x 3,0 cm. quantity 2 piecesStickersGerman flag black-red-golddimensions: 2,0 x 3,0 cm. quantity 2 pieces
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a...
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a...
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a...
Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a...