Top gear support GRP

Référence: 53

Dome plate GRP

At the top of the mechanics the dome plate supports the rotor shaft with the help of a 10 x 21 x 5 mm or 12 x 21 x 5 mm ballrace. To reduce the load on the ballrace a thrust bearing can also be fitted under the dome plate.

Référence: 830/48

Tail gear support

Tail gear support, GRP.

Référence: 830/54

Gear support aluminium

Gear support aluminium.

Référence: 53/17

Dome fittings set for PHT3-3

Dome fittings set for JetCat PHT3-3 turbine

Référence: 15/7

Eje intermedio

Référence: 54/14

Clamp ring 12 mm for rotor shaft

The clamp ring below the dome plate secures the rotor shaft inside the mechanics. Pay attention to achieve a safe installation, because the complete model is hanging on this clamp ring! Clamp ring for rotor shaft 12 mm Ø

Référence: 94/11

Bush 5 x 8 x 2.5 mm

Pack of 2

Référence: 870/20

Circlip for 8 mm diameter shaft

 Circlip for 8 mm Ø shaftpack of 2

Référence: 870/50

Front vertical frame, X-Treme

Not available

Référence: 107/14

Balls chrome-plated 2.5 x 5.5 mm

Chrome-plated brass balls are used to screw onto bell cranks or servo arms for connection to the ball-links of pushrods. The chromium plating prevents premature wear of the ball links.Content of the package: 25 pieces.

Référence: 340/36

Lay shaft hub

Not available

Référence: 500/361

Freewheel counter-clockwise

Not available

Référence: 107/42

Balls chrome-plated 2.0 x 4.8 mm

Chrome-plated brass balls are used to screw onto bell cranks or servo arms for connection to the ball-links of pushrods. The chromium plating prevents premature wear of the ball links.Content of the package: 10 pieces.

Référence: 870/21

Aluminium sleeve

 Content of the package1 piece

Référence: 7/50

Side frame left

Component part for foxy, Ord.No. 7007

Référence: 330/15

Bush 5 x 7 x 3.7 mm

Pack of 2