Exhaust, stainless steel

Référence: 25/9

Heat reflective mat

Between fuselage and exhaust tube a heat-reflecting mat avoids melting of the fibreglass. Even in smaller fuselages where conventional silencer systems are close to the inside surface, the heat reflective mat is useful as a heat shield.Heat reflective matheat rejectingsize approx. 300 x 700 mmmat thickness approx. 3 mm

Référence: 340/16

Exhaust for Lama

This exhaust system is designed for the Lama with turbine power system.

Référence: 350/16

Exhaust system for Alouette III

Not available

Référence: 530/17

Tapa de escape Ø 55 mm

Référence: 791/16

Exhaust tube for turbine, Cobra

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Référence: 9/26

Ceramic band 50x3x1000 mm

Not available

Référence: 350/17

Couvercle Ø 90 mm

When the turbine of a full-size helicopter is not running, the engine is protected with an exhaust cover which prevents foreign objects finding their way inside the turbine. This exhaust cover for model turbines is suitable for the Lama, Alouette III and any other machine with a 90 mm Ø exhaust pipe. Caution: it is essential to allow the exhaust pipes to...

Référence: 434/16

Exhaust tube for turbine, AIRWOLF, Bell 230 und Bell 430

On the AIRWOLF, Bell 230 and Bell 430 the forward thrust is eliminated by the scale division of the exhaust tube (enlarging of the cross-section) and exhausting up through the rotor disc.

Référence: 344/16

Exhaust for "Starwood" Lama

Not available

Référence: 268/16

Exhaust for XL-C

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Référence: 520/16

Exhaust tube for turbine

The outlets on the left and right hand sides offer the necessary cross-section and greatly reduce the forward thrust.This keeps the scale rear outlet while only discharging a small amount of the total exhaust gas.

Référence: 770/16

Exhaust tube for turbine, BK 117

On the BK 117 the forward thrust is eliminated by the scale division of the exhaust tube (enlarging of the cross-section) and exhausting up through the rotor disc.

Référence: 641/16

Exhaust system for Air-Crane

right / leftThis exhaust system is designed for the Air-Crane with turbine power system.

Référence: 900/16

Exhaust, stainless steel

Exhaust, stainless steel, for Ecureuil

Référence: 342/16

Exhaust for Gazelle

Not available

Référence: 120/16

EC 120 turbine exhaust pipe

Not available