Control bridge 2-part metal, 4 mm

Référence: 82/32

Washer for variable rocker 4 mm

Washer for variable rocker 4 mmContent of the package: 2 pieces

Référence: 68/22

Aluminium side frames

Aluminium side frames for swashplate driver 68/20 and 68/50. Content of the package: 2 pieces

Référence: 76/16

GRP blade holder, 5 mm ∅ hole

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with long linkage armfor two-blade rotor heads

Référence: 87/20

Actuating lever

The connection between mixer lever and variable rocker is carried out by an actuating lever, triple ballraced. Content of the package: 2 pieces

Référence: 1005/8

Kit de conversión varillaje directo para JetRanger XL eléctrico

Référence: 832/72

Aluminium centre piece, 12 mm

Aluminium centre piece for rotor head 722/72.

Référence: 72/5

Rotor brake, GRP

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Référence: 74/14

O-ring 3 x 16 mm soft

O-ring 3 x 16 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 72/45

Aluminium centre piece, 12 mm

Aluminium centre piece for 12 mm Ø main shaft

Référence: 71/14

Bras de compensateur

Pack of 2

Référence: 71/28

Articulation coudée avec goupille

Curved link, with pin

Référence: 74/5

Joint torique, souple 3 x 7 mm

O-ring 3 x 7 mm soft Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 76/19

GRP blade holder, 5 mm ∅ hole

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with short linkage armfor multi-blade rotor heads

Référence: 702/79

Flybar stainless steel 5 x 270 mm

Pack of 2

Référence: 85/1

Spacer 4 x 6 x 1.5 mm

Spacer 4 x 6 x 1.5 mm, brass Content of the package: 2 pieces

Référence: 71/26

Articulation, coudée

Curved link Content of the package: 2 pieces