Actuating lever

Riferimento: 73/15

Albero porta pale 8 x 115,9 mm

 Thrust bearing shaft8 Ø x 115.9 mm

Riferimento: 832/77

Spacer washer 6.0 x 21.8 x 4.0 mm

Spacer washer for rotor headContent of the package: 2 pieces

Riferimento: 82/53

Washer 3.5 x 12 x 3 mm, rubber

Washer 3.5 x 12 x 3 mm, rubber Content of the package: 2 pieces

Riferimento: 702/90

Aluminium centre piece

Aluminium centre piece for 12 mm Ø main shaft

Riferimento: 87/21

Washer for actuator arm 2.5 x 9 mm

Washer for actuator arm Content of the package: 2 pieces

Riferimento: 86/10

Ball collet 5 mm

Ball collets provide the fixation of double ball-links on the flybar, in order to settle the essential distance to the rocker.Ball collet 5 mm Ø, pack of 2, chrome-plated.

Riferimento: 78/41

Mixer lever cranked

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...

Riferimento: 54/16

Clamp ring pitch compensator 17 mm

The 17 mm Ø clamp ring is fitted to the rotor head centre piece, the steel pin slides in the guide slot of the pitch compensator. Rotate the clamp for fine adjustment so that your helicopter flies straight when you apply a pitch-axis command.Clamp ring for pitch compensator 17 mm Ø, length of the pin 30 mm.

Riferimento: 702/10

Corpo centrale Elastomero

Elastomer 2-blade-centre piece, GRP.

Riferimento: 117/3

Spacer washer 10 x 24.6 mm

Spacer washer for rotor headPack of 2

Riferimento: 704/39

cabezal de rotor de 4 palas 15 mm

Riferimento: 71/14

Bracci passo compensatore

Pack of 2

Riferimento: 480/53

Co-rotating dome coverage-set

You can fit to your Chinook heads a plate each that covers the dome and spins with the rotor head rpm. A pretty detail, that also can be found on the original Chinook helicopters. The plates / dome covers are mounted on the clamp rings of the main shafts.Pack of 2 plates incl. mounting material

Riferimento: 74/10

Anello 3 x 7 mm. duro

O-ring 3 x 7 mm hard Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 82/54

Stabilizer rods 4 x 120 mm

Stabilizer rods 4 x 120 mm Content of the package: 2 pieces

Riferimento: 707/2

Rotor head cover for 4-blade head

Rotor head cover for 4-blade head incl. screw.Laminated of carbonapprox. 120 mm ∅, 25 mm high