Screw fitting pushrod connector

Reference: 8/3

Tail rotor flange

The GRP tail rotor flange is used in full-fuselage helicopters such as the Jet Ranger, Bell 222 etc. to attach the tail rotor to the tail boom. The flange is supplied oversized, so that it can be fitted in all fuselages. Simply trim it to match the inside shape of the tail end of the fuselage, then glue it in place using Poxan-622 or UHU-Plus, and fitted...

Reference: 97/4

Servo linkage set

When you build your first model helicopter you will find all the linkage components required to connect the servos to the mechanics supplied with the RC set (German radio systems only). When you come to installing servos in other models you can use this servo linkage set which contains all the link balls, screws, nuts and screw-fitting pushrod...

Reference: 18/12

Aluminium tube 4.0 x 3.0 x 1000 mm

Aluminium tube 4.0 x 3.0 x 1000 mm

Reference: 791/28

Wing brace

The wing brace prevents the wings vibrating; it can be installed in the Cobra, depending on model version.

Reference: 33/20

Rotor blade support

An easy solution to the transport problem: This rotor blade support fits all helicopter trainers with 20 mm O.D. tail booms.Rotor blade supportfor rotor blades up to 65 mm chord

Reference: 3942

Servo packer

Servo packing pieces are used with direct-linked JR / Graupner roll-axis servos to give clearance to the pitch-axis servo. Pack of 10

Reference: 603/44

Adaptor, aluminium, 36 mm

Component part for fuselages, Ord.No. 6030 or 6031.

Reference: 10/46

Skid end cap 20 mm

Pack of 2

Reference: 18/1

PVC tube 3.0 x 2.0 x 980 mm, red

PVC tube 3.0 x 2.0 x 980 mm, red

Reference: 330/18

Gear support for tail drive

Component part for fuselages like Air-Crane, Bell 47 or Lama.Pack of 3

Reference: 33/4

Rotor bolsa de cuchillas 4 cuchillas Ø 2500 mm

Reference: 74

O-ring 3 x 8 mm hard

O-ring 3 x 8 mm hard Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Reference: 33/2

Rotor blade pouch 2-blade Ø 2100 mm

bag length: 98 cmmax. blade width: 9.5 cm

Reference: 18/10

PTFE tube for tail drive shaft

PTFE is used as a bearing for the 2 mm wire tail drive shaft (Ord.No. 17) or as a support guide for the 2 mm piano wire push rod (Ord.No. 21 and 800/12) Length: approx. 740 mm

Reference: 17/4

GRP bracket

 Content of the package1 piece

Reference: 13/21

Magnets for speed regulator

These magnets are suitable for use with all commercial speed regulators. For installation in the mechanics it is advisable the magnets be glued in a clamp ring Ord.No. 54/6, or as in the photo on the internal-tooth gear ring. Pack of 3