O-ring 3 x 16 mm soft

Riferimento: 79/10

Asta stabilizzatore 4 x 510 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Riferimento: 71 A

Corpo centrale, compensatore di passo

Centre piece for pitchcompensator, GFK, alone.

Riferimento: 91/67

Heat shrink for paddles

Heat shrinkapprox. 0.5 m, alone

Riferimento: 78/40

Set leva miscelatore

Mixer levers are an essential part of every flybar-controlled rotor head. From the swashplate a pushrod runs to the ballraced mixer arm which is screwed to the blade holder arm. The mixer levers transmit the control movement to the flybar via the double ball-link.Additionial accessories for the use of mixer levers are either two flanged ballraces or two...

Riferimento: 707/6

Rotor head cover for 4-blade head

Not available

Riferimento: 707/3

Rotor head cover for 3-blade head

155 mm diameter

Riferimento: 703/340

Washer for fastening multi-blade head

Not available

Riferimento: 87/12

Doble bola-link para Delta rotor

Riferimento: 117/20

Thrust bearing set complete

The standard version of our mechanics includes ground thrust bearing shafts with a of 8 mm Ø and a length of 110 mm.Thrust bearings absorb the high centrifugal forces exerted by the main rotor blades. The effect of the axial bearings is retained in full when the blade holders rotate.Thrust bearing set, complete as shown.

Riferimento: 832/71

Pitch mixer centre piece 12 mm

Pitch mixer centre piece, aluminium, 12 mm Ø

Riferimento: 480/53

Co-rotating dome coverage-set

You can fit to your Chinook heads a plate each that covers the dome and spins with the rotor head rpm. A pretty detail, that also can be found on the original Chinook helicopters. The plates / dome covers are mounted on the clamp rings of the main shafts.Pack of 2 plates incl. mounting material

Riferimento: 703/45

Rotor head linkage for Alouette III

This rotor head linkage is essential for the correct operation of the rotor head of the Alouette III due to its heavy take-off weight.

Riferimento: 86/5

Ball collet 4 mm, short

Ball collets provide the fixation of double ball-links on the flybar, in order to settle the essential distance to the rocker. Ball collet 4 mm Ø, overall length 19.7 mm, pack of 2, chrome-plated.

Riferimento: 74/5

Anello 3 x 7 mm. tipo morbido

O-ring 3 x 7 mm soft Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 54/13

Clamp ring pitch compensator 10 mm

On longer rotor shafts the clamp ring for the pitch compensator sits underneath of the centre piece directly on the rotor shaft.Clamp ring for pitch compensator 10 mm Ø, length of the pin 30 mm.

Riferimento: 832/87

90 degree link

A 90° twisted double ball-link connect the mixer lever to the ball collet on the flybar, suitable for the rotor head 722/72.Content of the package: 2 pieces