Heat shrink for paddles

Reference: 74/21

O-ring 3.5 x 12 mm hard

O-ring 3.5 x 12 mm hard Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Reference: 76/8

Ballrace spacer, steel

Ballrace spacer, steel Content of the package: 1 piece.

Reference: 82/31

Rocker, GRP

Rocker, GRP, for rotor head 702/70, alone

Reference: 87/20

Actuating lever

The connection between mixer lever and variable rocker is carried out by an actuating lever, triple ballraced. Content of the package: 2 pieces

Reference: 85/1

Spacer 4 x 6 x 1.5 mm

Spacer 4 x 6 x 1.5 mm, brass Content of the package: 2 pieces

Reference: 832/77

Spacer washer 6.0 x 21.8 x 4.0 mm

Spacer washer for rotor headContent of the package: 2 pieces

Reference: 72/42

CFRP plates for aluminium hub

This rotor head hub with its bonded-in carbon fibre plates is a real head-turner. The plates are simply glued into the existing recesses on both sides. We recommend silicone rubber, Ord.No. 10/11, as adhesive.CFRP plates for aluminium hub matching Ord.No. 832/72pack quantity: 2 plates

Reference: 87/21

Washer for actuator arm 2.5 x 9 mm

Washer for actuator arm Content of the package: 2 pieces

Reference: 76/25

Blade holder, blade grip 18 mm

Not available

Reference: 74/15

O-ring 2.5 x 12 mm, for Elastomer rotor head

Pack of 4Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Reference: 703/41

La palanca acodada, Alu

Reference: 82/32

Washer for variable rocker 4 mm

Washer for variable rocker 4 mmContent of the package: 2 pieces

Reference: 79/25

Flybar stainless steel 5 x 530 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Reference: 704/39

cabezal de rotor de 4 palas 15 mm

Reference: 702/15

15mm 2 blade centre piece

Aluminium centre piece for 15 mm Ø main shaft

Reference: 78/41

Mixer lever cranked

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...