Electro rotor head centre piece

Riferimento: 703/41

La palanca acodada, Alu

Riferimento: 72/10

Corpo centrale bipale

Rotor head centre piece for 2-bladed rotor head.

Riferimento: 91/65

Paddles 3-D

 Paddles1 pairapprox. 19 g eachfor 4 mm Ø flybar

Riferimento: 703/340

Washer for fastening multi-blade head

Not available

Riferimento: 80/20

Control bridge 2-part metal, 4 mm

Control bridge 2-part metal, for 4 mm Ø flybar.

Riferimento: 80/10

Ponte compensatore di passo

The control bridge actuates the flybar. The servos pass the control commands to the swashplate. The collective pitch compensator connected to the swashplate transfers the movement to the control bridge via the angled pushrods. The flybar accepts the control commands and passes them on to the blade holders and the rotor disc.Control bridge, GRP, for 4 mm ∅...

Riferimento: 74/7

Rotor head dampers for 2 blade FBL systems

Flybarless electronics have now become common. Where they are being used harder damping is required.For these cases Vario is now offering a harder damping of the blade shaft provided by a pretension absorbing element in the centre block.For the adjustment, the outer O-ring position can be selected between "hard" and "soft" flight characteristics.Important...

Riferimento: 10/81

Tubo silicone 5 x 7 x 100 mm

 Silicone sleeve5 x 7 x 100 mmtransparent

Riferimento: 702/10

Corpo centrale Elastomero

Elastomer 2-blade-centre piece, GRP.

Riferimento: 76/18

Blade holder twin blade bolt

Component part for a multi-blade rotor head for 10 mm or 12 mm Ø main shaft.

Riferimento: 832/69

Connecting elbow, aluminium

Connecting elbow, aluminiumPack of 2

Riferimento: 71/30

Compensatore di passo per 10 mm

Pitch compensator, complete, for 10 mm ∅ main shaft, centre piece aluminium

Riferimento: 87/21

Washer for actuator arm 2.5 x 9 mm

Washer for actuator arm Content of the package: 2 pieces

Riferimento: 76/19

GRP blade holder, 5 mm ∅ hole

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with short linkage armfor multi-blade rotor heads

Riferimento: 91/50

Paletti 105 x 60 mm per Ø 4+ 5 mm

Paddles1 pairapprox. 29 g eachfor ∅ 4 mm / 5 mm flybar

Riferimento: 80/30

Trascinatore

Control bridge 2-part metal, for 5 mm ∅ flybar.