Ballrace spacer, steel

Référence: 91/55

Lead for paddles

 Lead for paddlespack of 2approx. 8.5 g each

Référence: 257/45

Rocker kit for Bell UH / Bell 212 T-Rex

Not available

Référence: 72/45

Aluminium centre piece, 12 mm

Aluminium centre piece for 12 mm Ø main shaft

Référence: 480/53

Co-rotating dome coverage-set

You can fit to your Chinook heads a plate each that covers the dome and spins with the rotor head rpm. A pretty detail, that also can be found on the original Chinook helicopters. The plates / dome covers are mounted on the clamp rings of the main shafts.Pack of 2 plates incl. mounting material

Référence: 91/50

Palettes

Paddles1 pairapprox. 29 g eachfor ∅ 4 mm / 5 mm flybar

Référence: 54/18

Clamp ring for 12 mm

Same design as clamp ring 54/13, but for 12 mm Ø main rotor shaft.Clamp ring for pitch compensator 12 mm Ø, length of the pin 40 mm.

Référence: 832/76

Blade holder, 22 mm

Blade holder, 22 mm, alone

Référence: 91/60

Paddles

 Paddles1 pairapprox. 29 g eachfor 4 mm Ø flybar

Référence: 74/13

O-Ring 2 x 13 mm, soft

O-Ring2 x 13 mmSoftPackage: 8 pieces 

Référence: 82/31

Balancier, GFK

Rocker, GRP, for rotor head 702/70, alone

Référence: 91/67

Heat shrink for paddles

Heat shrinkapprox. 0.5 m, alone

Référence: 480/54

Anillo de sujeción plateado con 3 orificios

Référence: 74/10

Joint torique, dur 3 x 7 mm

O-ring 3 x 7 mm hard Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 82/52

Spacer washer for SKS rotor head

Spacer washer for SKS rotor head Content of the package: 2 pieces

Référence: 74/11

O-ring 1,5 x 11 mm soft

O-ring 1,5 x 11 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 78/41

Mixer lever cranked

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...